![]() ![]() Use the hotasx, get vjoy and joystick gremlin (I think they are free) and set up a control scheme similar to what I suggested. The hat switches cover Trim, DMS, TMS, CMS, Radar, Comms etc. You will also see a ministick/cursor.To get close to employing the f16, you should have many hats and a cursor. If you look at the real f16 controls, you will see many hat switches. Modern fighters involve multiple button presses to prepare for weapons employment. It would take less dedication with a better hotas. There will be less immersion and controller difficulties may frustrate you. It would take a lot of dedication as you not only have a very complex sim to learn, but also you will be fighting against controls that are not user friendly. Realistically, I think you will struggle with the HotasX and BMS. I’m only a beginner too, and I have been getting on and falling off the BMS bike for a few years (but it looks to be getting easier and easier over the years). That’s the usual usage if you have only very limitited number of physical buttons. The prior model had mapping software that was fine, HotasX does not have dedicated mapping software and I felt I had to give up on it when I moved to modern flight sims.Īs a real begginner in BMS, I don’t know if you can use Alternative Launcher to set so many shift states, or use something like Joystick Gremlin to set a “ctrl”, :shift" and “alt” button to get 3 shifted states.įor more than one shifted state (BMS only supports one) you could go with vJoy to create multiple virtual devices and JoystickGremlin to create and map shift button layers to the virtual vJoy devices and than use these vJoy Joysticks within BMS. Just the throttle from the “T.16000M FCS Hotas” would make a big difference. I would suggest a better HOTAS, eg Warthog, CH Products or even Saitek, Virpil etc as it will make things much easier to remember when engaged in many button switches. the HotasX really detracts from enjoying the game. ![]() It works well with WW2 planes and arcade/sim/etc games but fundamentally struggles with modern fighter sims due to the lack of hat switches and cursor/ministick.When I moved from WW2 planes to modern fighter sims (A10C) I bought the Warthog after struggling with a good setup on the HotasX. The base buttons I didn’t really understand.Īs a real begginner in BMS, I don’t know if you can use Alternative Launcher to set so many shift states, or use something like Joystick Gremlin to set a “ctrl”, :shift" and “alt” button to get 3 shifted have a Hotas X. I think that only leaves one button free - perhaps ECM or Next Nav Point or speedbrakes or cursor enter. I would add that to trigger, launch, mode button on the sidestick. The prior model had mapping software that was fine, HotasX does not have dedicated mapping software and I felt I had to give up on it when I moved to modern flight sims.įor the HotasX, I can’t recall where I got to, but my idea was to program the buttons on the throttle as separate shift buttons. ![]() ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |